SATO GL 4xxe Series Przewodnik Instalacji Pobierz pdf (Strona 9)

9

4

Assembling the Reader Module

Parts required

READER MOUNT

SUBASSEMBLY, GL4xxe

Tool(s) required

#1 Phillips + screwdriver - 8 in. lb.

1. Plug the antenna cable into the

port on the right side of the

Reader Subassembly as

indicated in Figure 4a.

2. Route the other end of the

cable into the electronics

section of the printer. The

cable connects to the white

connector on the printer’s main

PCB, near the moto. See

Figure 4c.

3. Position the reader

subassembly within the lower

part of the print head area.

while pulling any excess length

of interface cable slack back

into the electronics side of the

printer.

4. Attach the reader subassembly

to the printer with the supplied

screw (circled red in Figure

4b).

5. Tighten and torque the screw.

6. Close and latch the deck

assembly.

7. Position the antenna handle

above the printed orange-

colored marker’s location for

testing.

Note

When installing the reader

subassembly, make sure that the

antenna or power/data cables are

not crimped by any moving part

within the mounting area.

Figure 4b.

Insert the reader as

shown

Antenna

cable

Figure 4a.

Ports on the Reader

Subassembl

y

.

Figure 4c.

Insert the connector

as shown

1 2 3 4 5 6 7 8 9 10 11

Komentarze do niniejszej Instrukcji

Brak uwag